The headlights are individually adjustable vertically as well as horizontally.
The first step is to remove the left and right fairing inserts. These pictures illustrate the procedure for the removal of the right fairing insert. Do the same for the left.
|
|
| 1600 x 1200 | 1600 x 1200 |
To adjust beam vertically:
Turn the adjusting screw (back of headlight pod lower left for left light, lower right for right light) clockwise to lower beam, counterclockwise to raise beam.
To adjust beam horizontally:
Left headlight:
Turn the adjusting screw (back of headlight pod, upper right) clockwise to move beam to the left, counterclockwise to move beam to the right.
Right headlight:
Turn the adjusting screw (back of headlight pod, upper left) clockwise to move beam to the right, counterclockwise to move beam to the left.
Use an 8mm socket to turn the adjusting screws.
 |
 |
| 1600 x 1200 | 1600 x 1200 |
 |
Back to Main Page |
Last Updated: 03-06-2003
Copyright © 2001-03, Patrick Glenn, All Rights Reserved.
The information presented here reflects solely my personal experience with my motorcycle and is presented
for entertainment purposes only. No information presented here is to be relied upon for issues of rider safety
nor to replace the services of a qualified service technician.
Any attempts to follow or duplicate any of these procedures are done so completely at your own risk.
By reading the information on this site, you agree to assume complete responsibility for any and all actual
or consequential damages that may arise from any information presented herein.
Yamaha® and FZ1® are registered trademarks of the Yamaha Motor Corporation.
This site is not affiliated in any way with the Yamaha Motor Corporation.
