The shift lever is adjustable to accommodate a variety of shoe and/or boot toe thickness. The stock position was insufficient for my Caterpillar Steel-Toed work boots which are excellent for riding.

To adjust the shift lever height:

• Loosen both 10 mm lock nuts (Note: the lower nut is a reverse thread)
• Turn the Adjusting Rod to Either Raise or Lower the Shift Lever
• Tighten both Lock Nuts

1600 x 1200

Back to Main Page

Last Updated: 02-19-2003

Copyright © 2001-03, Patrick Glenn, All Rights Reserved.
Yamaha® and FZ1® are registered trademarks of the Yamaha Motor Corporation.
This site is not affiliated in any way with the Yamaha Motor Corporation.

The information presented here reflects solely my personal experience with my motorcycle and is presented for entertainment purposes only. No information presented here is to be relied upon for issues of rider safety nor to replace the services of a qualified service technician. Any attempts to follow or duplicate any of these procedures are done so completely at your own risk. By reading the information on this site, you agree to assume complete responsibility for any and all actual or consequential damages that may arise from any information presented herein.